Waveforms - [S - R Latch]

Waveforms - S' - R' Latch



If the above waveforms are applied to  Active LOW input S’-R’ Latch. Draw the resulting Q waveform assuming Q starts LOW. 
  • Use the truth table of the Active LOW input S' - R' latch to draw the resulting waveform.

  • The Q resulting waveform  is as follows.




Waveforms - S - R Latch





If the above waveforms are applied to  Active HIGH input S -R  Latch. Draw the resulting Q waveform assuming Q starts LOW.
  • Use the truth table of the Active HIGH input S - R latch to draw the resulting waveform.


  • The Q resulting waveform  is as follows.





 


Comments

Post a Comment

Popular posts from this blog

Active HIGH Input S-R Latch

Image
                                    LATCHES The latch is a type of bistable logic device [bistable : A digital circuit that has two gating inputs and output] and temporary storage device that hold single bit of information. Types of latches : SR Latch D Latch SR (SET - RESET) Latch Active HIGH input SR Latch -  [NOR Gate based SR Latch] In the Active HIGH input SR Latch, the latch changes its state based on inputs that are in the HIGH logic state.                                          S(Set) input is active HIGH, Latch will be Set(Q = 1)                     R(Reset) input is active HIGH, Latch will be Reset(Q = 0) Animation of Active HIGH input S-R Latch Case 1: R = 1      S = 0        ...
Read more

The S - R Latch as a Contact-Bounce Eliminator

Image
The S - R Latch as a Contact-Bounce Eliminator Contact bounce is a common problem that occurs when a mechanical switch or button is pressed or released.Instead of making a smooth and instantaneous transition from open to closed or  vice versa , the contacts may rapidly make and break contact several times before settling into a stable state.      Case 1: When the first switch connects to terminal A , the voltage at terminal B is zero. However , due to the bouncing phenomenon associated with the switch , the voltage at terminal A fluctuates several times before stabilizing at 5v.   Case 2 :  When the second switch connects to terminal B , the voltage at terminal A is zero. The voltage at terminal B undergoes several fluctuations before settling at 5v. To avoid the issue of contact bounce in a switch , the A and B terminals are connected through a active HIGH input S- R latch(NOR gate based S-R latch). Additionally , the outpus of terminals A and B can...
Read more

Flip - Flops

Image
Flip - Flops Flip - Flops are sequential digital circuits that are synchronous bistable devices and can store stable states(1 , 0)  of information. They are also known as bistable multivibrators . Output of the flip-flop changes only when a certain point (either the rising or falling edge) on the triggering input called C lock(CLK) . An edge-triggered flip-flop only changes its state when the clock pulse shifts from low to high – rising edge(positive edge) or high to low-falling edge (negative edge), and it only responds to its inputs during these clock transitions. There is a difference in the logic symbols for positive edge-triggered and negative edge-triggered flip-flops.The negative edge-triggered flip-flop symbol is similar to the positive edge one  but with an inversion bubble or small circle added to the clock input line, indicating that the flip-flop responds to the falling edge (negative edge) of the clock signal. Here is an example of the logic symbol for a D ...
Read more